| 當前位置：首頁->方案設計 |
|
| SSL5301T 12W調光LED電源解決方案 |
|
|
| 文章來源： 更新時間：2014/7/7 10:45:00 |
在線咨詢： |
| |
NXP公司的SSL5301T是可調光控制器,具有高可調光兼容性,調光范圍大,單級拓?fù)銹CB占位面積小,集成了起動JFET,可選擇模式以得到高功率系數或低波紋,使得LED電源較寬,主要用在通用LED照明.本文介紹了SSL5301T主要優勢和特性,框圖,幾種典型應用電路以及12W評估板SSL5301DB1213主要指標,電路圖,材料清單,PCB元件布局圖和變壓器T1電路與主要指標..
The SSL5301T is a mains dimmable controller IC, intended to drive dimmable LEDs in general lighting applications.
SSL5301T主要優勢:
• High dimmer compatibility
• Selectable modes for high power factor or low ripple, allowing a wide LED power range
• Large dimming range
• Single stage topology for small PCB footprint
• Ease of design-in
• Integrated start-up JFET
• Low electronic Bill Of Material (BOM)
• Supports multi-lamp applications
• Various converter topologies supported
The IC drives an external switch for easy power scaling. It has been designed to start up directly from the High-Voltage (HV) supply by an internal high-voltage current source. Flyback, buck and buck-boost circuit topologies are supported. Primary side sensing provides accurate output current control.
The IC can detect all known mains dimmer types and translate the dimmer setting to a continuous LED current in multiple ways. It can operate in three switching modes at two switching frequency ranges. It offers tradeoffs between the output current ripple, the mains current Total Harmonic Distortion (THD) and the application size. The IC incorporates all required protection features.
SSL5301T主要特性:
LED controller IC for driving strings of LEDs or high-voltage LEDs from rectified mains
High-efficiency switch mode buck, flyback or buck-boost controller driving an external power FET
Two maximum switching frequencies for highest efficiency or smallest application size
Zero current switching at switch turn-on
Zero voltage or valley switching at switch turn-on
Selectable low THD or low LED current ripple modes
Leading, trailing and intelligent dimmer detection
Two built-in dim curves
LED current accuracy within 4 % across variations in components and conditions
No binning on LED forward voltage required
Built-in Protections:
UnderVoltage LockOut (UVLO)
Leading-Edge Blanking (LEB)
OverCurrent Protection (OCP)
Internal OverTemperature Protection (OTP)
Brownout protection
Output short protection
Output open protection
Mains synchronization loss protection
Bleeder dissipation protection
Low component count LED driver solution
Compatible with wall switches with built-in indication light during standby
Operates well in multiple-lamp arrangements
IC lifetime matches or surpasses LED lamp lifetime
SSL5301T應用:
Compact mains dimmable LED lamps with accurate, dimmable current output for single mains voltages, including 100 V (AC), 120 V (AC) and 230 V (AC). External components determine the power level. The power level ranges from 4 W to over 25 W. Applications fit in common form factors like PAR, GU10, A19, and the candle form factor
圖1. SSL5301T框圖
圖2. SSL5301T降壓-升壓轉換器電路圖:低波紋,輸入=230VAC,輸出=90V/50mA
圖3. SSL5301T反激轉換器電路圖:低波紋,輸入=230VAC,輸出=36V/250mA
圖4. SSL5301T降壓轉換器電路圖:低波紋,輸入=120VAC,輸出=37V/290mA
12W評估板SSL5301DB1213
This user manual describes the operation of the SSL5301DB1213 230 V 12 W dimmable LED driver featuring the SSL5301 using a flyback topology. The SSL5301DB1213 demo board has a form factor that is compatible with the base of an A19 LED lamp fitting used in Solid State Lighting (SSL) applications.
The SSL5301DB1213 demo board input is connected to the 230 V mains. Avoid touching the board while it is connected to the mains voltage and when it is in operation. An isolated housing is obligatory when used in uncontrolled, non-laboratory environments.
Galvanic isolation from the mains phase using a fixed or variable transformer is always recommended.
The board is optimized for a 230 V/50 Hz mains supply. In addition to the mains voltage optimization, the board is designed to work with multiple LEDs or an LED module with a 40 V forward voltage. The mains connection of the SSL5301DB1213 demo board is different from other general evaluation/reference boards.
12W評估板SSL5301DB1213主要指標:
圖5. 12W評估板SSL5301DB1213外形圖
圖6. 12W評估板SSL5301DB1213電路圖
12W評估板SSL5301DB1213材料清單:
圖7. 12W評估板SSL5301DB1213 PCB元件布局圖
圖8. 12W評估板SSL5301DB1213變壓器T1外形圖
變壓器T1指標:
 |
| |
|
|
|
|
|
| |
|
| |
|
|
