伊人大杳蕉在线影院75_一点不卡v中文字幕在线_黄桃AV无码免费一区二区三区_中文字幕人妻互换激情

·I2S數字功放IC/內置DSP音頻算法功放芯片 ·馬達驅動IC ·2.1聲道單芯片D類功放IC ·內置DC/DC升壓模塊的D類功放IC ·鋰電充電管理IC/快充IC ·無線遙控方案 ·直流無刷電機驅動芯片

當前位置：首頁->方案設計

TPS1H100－Q1汽車車體控制模塊驅動器(BCM)參考設計

文章來源：更新時間：2015/4/7 9:52:00

在線咨詢：

張代明 3003290139

姚紅霞 3003214837

鄢先輝 2850985542

13713728695

TI公司的TPS1H100-Q1是全保護的高邊功率開關,集成了NMOS功率FET和電荷泵,工作電壓3.5V-40V,待機電流小于0.5uA,工作溫度–40 到150℃,適合各種電阻,電感和電容負載,主要用在汽車電子如HVAC,車體控制模塊,超聲輔助停車,汽車干式雙離合器變速器和車載全景可視系統.本文介紹了TPS1H100-Q1主要特性,框圖,典型應用電路圖以及汽車車體控制模塊驅動器(BCM)參考設計TIDA-00296主要特性,框圖,電路圖和材料清單.
The TPS1H100-Q1 is a fully protected high-side power switch, with integrated NMOS power FET and charge pump, targeted for the intelligent control of the variable kinds of resistive, inductive, and capacitive loads. Accurate current sense and programmable current limit features differentiate it from the market.

TPS1H100-Q1主要特性:
Qualified for Automotive Applications
AEC-Q100 Qualified With the Following Results:
Device Temperature Grade 1:–40℃ to 125℃ Ambient Operating Temperature Range
Device HBM ESD Classification Level H3A
Device CDM ESD Classification Level C4B
Single-Channel Smart High-Side Power Switch With Full Diagnostics
Version A: Open-Drain Status Output
Version B: Current Sense Analog Output
Wide Operating Voltage 3.5 to 40 V
Very-Low Standby Current, <0.5 µA
Operating Junction Temperature, –40 to 150℃
Input Control, 3.3-V and 5-V Logic Compatible
High-Accuracy Current Sense, ±30 mA at 1 A, ±4 mA at 5 mA
Programmable Current Limit With External Resistor, ±20% at 0.5 A
Diagnostic Enable Function for Multiplexing of MCU Analog or Digital Interface
Tested According to AECQ100-12 Grade A, 1 Million Times Short to GND Test
Electrical Transient Disturbance Immunity Certification Certification of ISO7637-2 and ISO16750-2
Protection
Overload and Short-Circuit Protection
Inductive Load Negative Voltage Clamp
Undervoltage Lockout (UVLO) Protection
Thermal Shutdown/Swing With Self Recovery
Loss of GND, Loss of Supply Protection
Reverse Battery Protection With External Circuitry
Diagnostic
On/Off State Output Open/Short to Battery Detection
Overload and Short to Ground Detection and Current Limit
Thermal Shutdown/Swing Detection
14-Pin Thermally-Enhanced PWP Package
TPS1H100-Q1主要應用:
Automotive - HVAC
Body Control Module
Ultrasonic Park Assist
Automotive Dry Double Clutch Transmission
Surround View

圖1. TPS1H100-Q1框圖

圖2. TPS1H100-Q1典型應用電路圖

汽車車體控制模塊驅動器(BCM)參考設計TIDA-00296
TIDA-00296 is a reference design that highlights TI’s high-side and low-side relay, motor, and load driver portfolios. The loads for this design (door locks, window lifts, seat heaters, HVAC, lamps, and LEDs) were chosen to show the range of loads that a BCM can drive and how TI’s solutions fit into these areas.

BCM參考設計TIDA-00296主要特性:
Robust and versatile driver products for driving various loads:
High-side pre-FET Drivers (LM9061/TPIC44H01)
Seat Heaters
Low-Side Driver (TPL7407L)
Lamps
High-Side Driver (LMD18400/TPS1H100-Q1)
HVAC Blower, Window/Windshield Actuators
Linear LED Driver (TPS92630)
LEDs
Smart drivers have diagnostic and protection capabilities via I2C and SPI
Reverse polarity protection on the power stage of the design
pre-FET drivers are used to drive discrete FETs allowing the design to have flexibility with load driving requirementsHighlights the ability of the BCM to directly drive loads with higher current requirements (~4500mA)
TIDA-00296 Board